FORD 1999 Taurus - Manual (Page 33)

28
ț To START the Elapsed Time count when it
is stopped without resetting the counter,
briefly press the reset control for less than 2
seconds.
ț To reset the elapsed time counter, hold the
reset control down until the count reads
00:00:00 (about 2 seconds).
Compass
Pressing the COMPASS control will display one of
the following eight compass displays: North,
Northeast, East, Southeast, South, Southwest, West
and Northwest.
For additional information on the compass operation
and for instructions to adjust the compass, see
Electronic Compass in this chapter.
System Check
A press of the SYSTEM CHECK control causes the
M/C to cycle through a status of each of the
systems being monitored. For each of the monitored
systems, the M/C will indicate either an OK
message or a warning message for two seconds. The
sequence of the system check report is as follows:
❑ Engine Oil Life Status
❑ Engine Oil Life Left
❑ Engine Oil Level
❑ Voltage Level
❑ Engine Coolant Temperature
❑ Engine Coolant Level
❑ Washer Fluid Level
❑ Doors Closed (Driver and Rightside)
❑ Trunk Closed
❑ Exterior Lamps (Head, Front Turn, Brake and
Tail)
❑ Air Ride System
File:03fnis8.ex
Update:Thu Jun 27 10:00:37 1996