Fostex VF160EX - Manual (Page 77)

77
3. Press the [ENTER/YES] key.
The tracks are instantly exchanged.
“
Completed! ” appears on the display when the tracks are
successfully exchanged. Then the LCD returns to the
original time base display.
• Exchange in mono or 2-track units
1. Turn the [JOG] dial while “1-8” is flashing.
You can select among mono tracks (1 through 24) and
stereo 2 tracks (1&2, 3&4, .... 23&24), as well as 8 tracks.
The right column shows the same unit, according to the
selection on the left column as shown in the figure below.
Therefore, you should select track(s) in the left column first
and then select track(s) in the right column.
<Note>
The numbers on the right and left of mono tracks mean
the same thing, therefore, the numbers can be reversed
and still mean the same thing.
In other words, “
04<=>01 ” and “ 01<=>04 ” mean the same
thing. This representation means that tracks 1 and 4
will be exchanged, regardless of which number comes
first.
<Caution>
If you select the same track(s) for both the left and right
columns (for example, "
04<=>04 ", " 01&02<=>01&02 " or
" 01-08<=>01-08 "), you cannot carry out a track exchange.
" Select Err" appears on the display and the display re-
turns to the previous one.
3. Press the [ENTER/YES] key.
The tracks are instantly exchanged.
“
Completed! ” appears on the display when the tracks are
successfully exchanged. Then the LCD returns to the
original time base display.
Flashing
Flashing
• Exchange in 8-track units
1. While "01-08" on the left is flashing, press the [HOLD/>] or
[F FWD] key to make "09-16" flashing.
2. Turn the [JOG] dial to select “09-16” or “17-24” to flash on
the display.
2. Press the [HOLD/>] or [F FWD] key to make the right
column flash, and select the desired track(s) using the
[JOG] dial.
Flashing
Flashing