Grizzly G1023SL - Manual (Page 11)

G1023SL/G1023SLX Left-Tilting 10'' Table Saw -9-
We do not recommend the use of extension cords
on 220V equipment. Instead, arrange the place-
ment of your equipment and the installed wiring to
eliminate the need for extension cords. Should it
be necessary to use an extension, make sure the
cord is rated Standard Service (grade S) or bet-
ter. Refer to the chart in
Section 1: Safety to
determine the minimum gauge for the extension
cord. The extension cord must also contain a
ground wire and plug pin. Always repair or
replace extension cords when they become worn
or damaged.
Extension Cords
Always utilize a qualified electrician when doing
any electrical work on this equipment.
Wiring
We have covered some basic electrical
requirements for the safe operation of your
machine. These requirements are not neces-
sarily comprehensive. You must be sure
that your particular electrical configuration
complies with local and state codes. Ensure
compliance by checking with your local
municipality or a licensed electrician.