Grizzly G1023SL User Manual
Page 25
G1023SL/G1023SLX Left-Tilting 10'' Table Saw
-23-
Figure 26.
Shim procedure diagram A.
Figure 27.
Shim procedure diagram B.
11.
Refer to
Figures 26 and 27,
for shim place-
ment. If the distance of A is shorter than B,
shim(s) will need to be placed under corners
#1 and #2. If the distance of B is shorter than
A, shim(s) will need to be placed under cor-
ners #3 and #4. Very thin shim stock works
well, just make sure they are all the same
thickness, and you put an equal number
under each of the two corners.
12.
Tighten down one bolt a small amount and
then move on to each of the others, tighten-
ing each down the same amount. Continue
to rotate through the bolts, tightening them a
little each time until they are all secure.
13.
Now recheck the blade to miter slot at 90°
and 45° by repeating
Steps 1-5
. If the dis-
tance of A and B are equal, continue to the
“Miter Gauge” instructions. If the distances
are still off, repeat
Steps 9-12
.
14.
Once you feel you have the miter slot adjust-
ed to the blade, recheck all measurements
and be sure the table mounting bolts are
secure. Repeat
Step 10
in
Section 4:
Assembly
, “Blade Guard/Splitter.” Also, if
you ever remove the table in the future, be
sure to make note of shim placements and
reassemble exactly how it came apart.