Grizzly G1023SL - Manual (Page 22)

-20- G1023SL/G1023SLX Left-Tilting 10'' Table Saw
9. Moving the arbor bracket moves the V-belts
and pulleys out of alignment, so adjustment
of the motor pulley is required. Simply loosen
the setscrew in the middle groove of the pul-
ley, and slowly slide the pulley toward the
end of the motor shaft. Once the V-belts are
back in alignment, tighten the setscrew
securely.
10. Recheck the guard alignment to the blade
and to the table top. Adjust as necessary and
tighten down all the bolts before use. If the
blade guard is properly aligned, re-attach the
table, making sure there is adequate blade
clearance through all blade adjustments.
11. Adjust the blade to 45°. Raise and lower it
through the full range. Re-adjust the blade to
90°, then raise and lower it through the full
range. There should be no contact between
the blade, the base, the table insert, or any
other part of the saw. If there is contact,
repeat
steps 7-9 .
Figure 22. Arbor bracket adjustment locations.
5. Recheck the splitter alignment to the blade
and to the table top. Adjust as necessary and
tighten all the bolts before use. If the blade
guard is properly aligned, please skip ahead
to
step 10 ; otherwise, continue with the next
step.
6. If the splitter is positioned to the left of the
blade, alignment cannot be achieved by
washer placement. Adjustment of the front
support bracket is required. See
Figure 21
for adjustment details. Loosen the (2) adjust-
ment screws and move left or right.
7. If this adjustment does not allow enough
movement of the splitter, remove the table
and wings, and set them to one side.
8. The arbor bracket and motor pulley needs
adjusting. Loosen the adjustment bolt shown
in
Figure 22 , and slowly slide the arbor
bracket towards the end of the shaft. Only
move the arbor bracket a distance equal to
the amount of misalignment between the
blade and the splitter, or a little more. You
can always adjust the splitter back to the left
with washers. Tighten the adjustment bolt
securely.
The table and wings
represent a very heavy
load. DO NOT over-
exert yourself while lift-
ing or moving the table
and wings – get assis-
tance.
Arbor Bracket
Adjustment Bolt