Grizzly G0524 - Manual (Page 21)

G0524 Rip Saw -19-
Components and Hardware Needed: Qty
Auxiliary Roller Brackets (Left) .................... 2
Auxiliary Roller Brackets (Right) ................. 2
Auxiliary Rollers ........................................... 4
Hardware Bag
—Cap Screws M6-1.0 x 16 .................. 8
—Setscrews M6-1.0 x 30 ..................... 4
—Lock Washers 6mm .......................... 8
—Flat Washers 6mm ........................... 4
—Hex Nuts 6-1.0 .................................. 4
Tools Needed:
Allen Wrench 3mm ...................................... 1
Allen Wrench 4mm ...................................... 1
Allen Wrench 5mm ...................................... 1
Wrench 10mm ............................................. 1
Wrench 13mm ............................................. 1
The Model G0524 is supplied with 4 auxiliary
rollers (
Figure 17) that can be attached when rip
cutting workpieces shorter than 8". Note—These
auxiliary rollers can be left on the machine when
cutting longer boards; however, the maximum
thickness cutting capacity of the saw is reduced
to 2
1 ⁄
4
".
Figure 16. Dust collection hook-up.
An efficient and clean dust collection system is
essential to the proper function of the rip saw.
Ensuring a healthy work environment is also
dependent upon cleaning and maintaining the
dust collection system. Clamp a 4" hose from the
dust collection system to the dust port (
Figure
16).
Figure 17. Auxiliary roller (1 of 4).
Auxiliary Roller
Auxiliary Rollers Dust Collection