Grizzly G0659 - Manual (Page 16)

-14-
g0659 9" x 14" Vertical Metal-Cutting Bandsaw
Assembly
To assemble the bandsaw:
1. Attach one of the roller brackets with two hex
bolts and lock washers, as shown in figure
9.
figure 9. roller bracket.
2. slide one end of the roller into the attached
bracket, slide the other bracket over the other
end of the roller, then attach the bracket to
the table with the remaining hex bolts and
lock washers (
figure 10).
3. slide the counterweight onto the counter-
weight rail and secure in position with the lock
knob (
figure 11).
figure 10. Mounting roller.
4. twist the knob onto the saw frame release
lever until it is snug ( figure 12).
roller Bracket hex Bolt
lock Washer
roller
Mounting Bracket
figure 11. Counterweight installation.
lock Knob
Counterweight
Counterweight rail
figure 12. saw frame release lever knob.
saw Frame
release lever
Knob