Grizzly G0659 - Manual (Page 44)

-42-
g0659 9" x 14" Vertical Metal-Cutting Bandsaw
Blade Scraper &
Wheel Brush
the lower wheel compartment contains the blade
scraper and wheel brush. these are designed to
clean chips off the blade and wheel tire as the
bandsaw is operating. Always adjust the blade
scraper and wheel brush at the same time.
To adjust the blade scraper and brush:
1. disConneCt BAndsAW FroM poWer!
2. lock the saw frame in the rearmost position,
then remove the right side cover.
3. loosen the screws that hold the blade scrap-
er in place ( figure 59).
4. reposition the blade scraper as close as
possible to the blade without touching it, then
re-tighten the screws.
5. loosen the screws that hold the wheel brush
in place ( figure 60).
figure 59. Blade scraper.
Blade scraper
screws
6. Adjust the wheel brush so that it makes good
contact with the wheel but the bristles are not
overly bent, then re-tighten the screws.
7. replace the side cover.
figure 60. Wheel brush.
screws
Wheel Brush