Grizzly G0659 - Manual (Page 17)

g0659 9" x 14" Vertical Metal-Cutting Bandsaw
-15-
Test Run
once the setup is complete, test run your machine
to make sure it runs properly and is ready for
regular operation.
the test run consists of verifying the following: 1)
the motor powers up and runs correctly, and 2)
the machine is in working order.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on page 37.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Connect the machine to the power source.
4. Verify that the machine is operating correctly
by turning the machine on. to operate the
switch, slide the red button up to open the
stop latch, then press the green start button
under the latch.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
5. turn the machine OFF.
6. Continue to Recommended Adjustments
before using machine further.
For your convenience, the adjustments listed
below have been performed at the factory.
Because of the many variables involved with ship-
ping, however, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine before
putting it into use.
step-by-step instructions for these adjustments
can be found in the
OpERATIONS section start-
ing on page 16.
factory adjustments that should be verified:
1. saw Frame stop (refer to page 21).
2. Blade guides (refer to page 27).
3. V-Belt pulley Alignment (refer to page 39).
4. Wheel alignment (refer to page 40).
Recommended
Adjustments