GE PROFILE PDE9900 - Manual (Page 19)

– 19 –
Door Interlock Switch
The door interlock switch opens the L1 circuit when
the door is open. The switch is replaced as an
assembly.
The door panel and escutcheon must be removed to
access the door latch switch. (See
Door Panel .)
The door latch switch is held in place by 2 Phillips
head screws.
If the door is unlatched while running a wash cycle,
the cycle countdown will pause and the vent will
open. If unlatched for more than 15 seconds during
a wash cycle, the control will beep once every 15
seconds until the door is relatched.
Door Interlock Switch Strip Circuit
J2-10
DOOR
INTERLOCK
NO COM
BLK/WHITE
BLK/WHITE
BLK
J2-11
3
1
2
Detergent/Rinse Module
The door panel must be removed to access the
detergent/rinse module. (See
Door Panel .)
The detergent rinse module is held in place by 6
Phillips head screws and 2 brackets.
At the second activation (3), the lever lifts the
con nect ing rod by the notch. This action lifts the
rinse dispenser plunger and re leas es the rinse
agent. When deactivated, the lever returns to its
original start ing position.
The detergent/rinse mod ule au to mat i cal ly
dis pens es both the de ter gent and the rinse agent
at the ap pro pri ate times. The module is activated 2
times during a wash cycle. Detergent is dispensed
at the beginning of the main wash cycle and
rinse agent at the beginning of the fi nal rinse. The
detergent/rinse module can be activated using the
Service Mode .
The fi rst time the module is activated:
The lever slides up the right-hand path of the
connecting rod (1). This action releases the
de ter gent cover.
When deactivated (2), the lever returns down the
left-hand path and comes to rest under the notch in
the center of the connecting rod.
Door Interlock Switch Strip Circuit
1200 - 2800 Ω
DETERGENT MODULE
RED/YELLOW WHITE
J2-9
Disconnect
Bracket