Dust collection – Grizzly G0612 User Manual

Page 17

Advertising
background image

G0612 6" Jointer

-15-

Components and Hardware Needed:

Qty

Dust Chute ........................................................ 1
Dust Collection Bag ........................................... 1
Dust Bag Clamp ................................................ 1
Phillips Head Screwdriver ................................. 1

Dust Collection

The Model G0612 creates substantial amounts

of wood dust while operating. DO NOT oper-

ate this machine without an adequate dust

collection system. Failure to use a dust col-

lection system can result in short and long-

term respiratory illness.

Figure 19. Installing the dust chute.

5. Loosen the two jack screws, then, using a

scrap wood block, push the knife blade down
until both ends are sightly below the straight-
edge.

6. Using the 4mm hex wrench, turn each jack

screw clockwise

1

/

8

of a turn at a time until

each end of the knife touches the straight-
edge evenly.

7. Rotate the cutterhead without disturbing the

knife clamp to check the knife height.

—If the knife moves the straight edge slightly

(

1

/

8

") forward and back on the table, the

knife height is set correctly.

—If the knife does not move the straightedge

slightly (

1

/

8

") forward and back on the table,

continue to make fine adjustments with the
jack screws until the knife is set correctly.

8. When the knife height is set correctly, firmly

tighten each of the knife clamp screws.
When the clamp is set firmly, tighten the jack
screws.

To Install the dust collection chute and bag:

1. Install the dust chute as shown in Figure 19.

Advertising