Squaring stock – Grizzly G0612 User Manual
Page 25
Advertising
G0612 6" Jointer
-23-
��
��
��
Squaring stock involves four steps performed
in the order below:
1. Surface Plane on the Jointer—The concave
face of the workpiece is surface planed flat with
the jointer.
Previously
Jointed Edge
Previously
Surface
Planed Face
2. Surface Plane on a Thickness Planer—The
opposite face of the workpiece is surface planed
flat with a thickness planer.
3. Edge Joint 0n the Jointer—The concave
edge of the workpiece is jointed flat with the
jointer.
4. Rip Cut on a Table Saw—The jointed edge
of the workpiece is placed against a table saw
fence and the opposite edge cut off.
Squaring Stock
Advertising