Grizzly Deluxe Bandsaw G0555LX - Manual (Page 15)

G0555LX (Mfg. Since 3/13)
-13-
inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
inventory (see figure 6) Qty
a. table .......................................................... 1
b. saw blade 93 1 ⁄
2
" x 3 ⁄
8
" x 6 tpi ................... 1
c. bandsaw body ........................................... 2
d. trunnion base ............................................ 1
e. Front Fence rail ......................................... 1
f. rear Fence rail ......................................... 1
g. Miter gauge assembly ............................... 1
h. Fence assembly ......................................... 1
i. trunnion lock Knobs.................................. 2
J. upper stand braces ................................... 2
K. stand top ................................................... 1
l. stand sides ................................................ 2
m. lower stand braces ................................... 2
n. hardware bag ............................................ 1
—table insert ............................................. 1
—hex bolts
5 ⁄
16
"-18 x 1 1 ⁄
2
" (bandsaw) ........ 4
—hex nuts 5 ⁄
16
"-18 (bandsaw) ................... 4
—lock Washers 5 ⁄
16
" (bandsaw) ................ 4
—Flat Washers 5 ⁄
16
" (bandsaw) .................. 8
—Cap screws 1 ⁄
4
"-20 x 5 ⁄
8
" (Fence) ............ 2
—hex bolts 1 ⁄
4
"-20 x 3 ⁄
4
" (Fence) ................ 2
—Flat Washers 1 ⁄
4
" (Fence) ........................ 2
—hex bolts 1 ⁄
4
"-20 x 5 ⁄
8
" (stand) .............. 16
—Flat Washers 1 ⁄
4
" (stand)....................... 16
—Flange nuts (stand).............................. 16
—stand Feet
3 ⁄
8
"-16 x 2" (stand) ................ 4
—Carriage bolts 5 ⁄
16
"-18 x 5 ⁄
8
" (stand) ........ 8
—Flange nuts 5 ⁄
16
"-18 (stand) .................... 8
—hex nuts 3 ⁄
8
"-16 (stand Feet) .................. 8
—Flat Washer 3 ⁄
8
" (stand Feet) .................. 8
—Combo Wrench 10 x 12mm .................... 1
—hex Wrench 5mm ................................... 1
d
e
C
F
g
h i
J
figure 6. Main components inventory.
b
K
l
M n
a