Grizzly Deluxe Bandsaw G0555LX - Manual (Page 31)

G0555LX (Mfg. Since 3/13)
-29-
5. use the fine ruler to measure the distance
between the straightedge and miter slot at the
front and back of the table (see
figure 39).
— if the distances are the same, no further
adjustments are required.
— if the distances are different, continue with
step 6.
6. loosen the six flange bolts that secure
the table to the trunnion brackets (see
figure 40).
7. position the table so that the distances are
equal between the straightedge and miter
slot at the front and the back of the table.
8. taking care not to move the table further, re-
tighten the flange bolts.
9. verify the setting and, if necessary, repeat
this procedure until you are satisfied with the
adjustment.
figure 40. location of trunnion bracket flange
bolts.
Flange bolts
(3 of 6)
aligning fence
to ensure accurate cutting when using the fence,
the face of the fence must be parallel to the table
miter slot and, thus, to the side of the blade.
tools needed Qty
hex Wrench 5mm .............................................. 1
to align the fence parallel with the miter slot:
1. Make sure the miter slot is parallel with the
blade, as instructed in the previous aligning
table procedure.
2. disConneCt bandsaW FroM poWer!
3. install the fence on the right side of the blade,
even with the edge of the miter slot, then lock
it in place.
— if the fence is parallel with the miter slot, no
additional adjustment is necessary.
— if the fence is not parallel with the miter
slot, proceed to step 4.
4. loosen the four fence adjustment cap screws
shown in figure 41, adjust the fence paral-
lel to the miter slot, then re-tighten the cap
screws to secure the setting.
figure 41. location of the fence adjustment cap
screws.
Cap screws