Grizzly Deluxe Bandsaw G0555LX - Manual (Page 35)

G0555LX (Mfg. Since 3/13)
-33-
table tilt
the table can be tilted to make angled or beveled
cuts. a simple tilt scale is provided on the trun-
nion for a quick gauge (see
figure 44). For more
accurate results use a protractor.
note: When tilting the table to the left, the positive
stop bolt must be lowered. Be sure to re-adjust it
when returning the table to be perpendicular with
the blade.
to tilt the table:
1. disConneCt bandsaW FroM poWer!
2. loosen both table lock knobs underneath the
table.
3. tilt the table to the desired angle, then re-
tighten the lock knobs.
figure 44. table tilt controls.
tilt scale
& pointer lock Knob
(1 of 2)
blade speed
the Model g0555lX offers blade speeds of 1800
and 3100 FpM. speed changes are made by re-
positioning the v-belt in different pulley grooves.
Keep in mind, cutting results are not just related
to blade speed. other factors include: the type of
workpiece, the blade being used for the operation,
and the feed rate.
use the chart below as a general guide for
which blade speeds to use for various opera-
tions:
type of cutting operation
blade speed
(fpm)
general Woodworking 3100
super dense hardwood 1800
Fast/average Feed rate 3100
requires slow Feed rate 1800
rough edges acceptable 3100
requires smooth edges 1800
Quick, production Cuts 3100
detailed, intricate Cuts 1800
tools needed Qty
hex Wrench 6mm .............................................. 1
to change the blade speed:
1. disConneCt bandsaW FroM poWer!
2. open the lower wheel cover, and loos-
en the motor mount cap screws shown in
figure 45.
figure 45. Motor mount cap screws.
Motor Mount
Cap screws