Inventory – Grizzly G0457 User Manual
Page 16
-14-
g0457 14" industrial Bandsaw (Mfg. Since 5/11)
Inventory
contents (figures 4–5)
Qty
A. Bandsaw Unit ............................................. 1
B. Cabinet Stand ............................................. 1
c. Feet
3
⁄
8
-16 (Stand) ...................................... 4
D. Motor .......................................................... 1
E. Blade tension Knob ................................... 1
f. lever handle (Quick release) ................... 1
G. table ........................................................... 1
h. trunnion hand Knobs M10-1.5 (table) ....... 2
I. Miter gauge ................................................ 1
J. Fence Assembly ......................................... 1
K. resaw Fence ............................................. 1
L. Front rail .................................................... 1
M. rear rail .................................................... 1
N. Moving plate (Fence).................................. 1
O. lever handle w/nut (Fence) ....................... 1
p. locking Adjustment handle (Fence) .......... 1
hardware (Not shown)
•
Cap Screws M8-1.25 x 25 (Motor) .............. 2
•
lock Washers 8mm (Motor) ....................... 2
•
Fender Washers 8mm (Motor) ................... 2
•
Flat Washers 6mm (Front rail) .................. 2
•
lock Washers 6mm (Front rail) ................. 2
•
hex Bolts M6-1 x 20 (Front rail) ................ 2
•
Cap Screws M6-1 x 16 (rear rail) ............. 2
•
Flat Washer 8mm (Fence) .......................... 1
•
Flange Screw (Blade tension Knob) .......... 1
•
hex Bolt M8-1.25 x 80 (positive Stop) ........ 1
•
hex nut M8-1.25 (positive Stop) ................ 1
•
Carriage Bolts M8-1.25 x 20 (Stand) .......... 6
•
Flange nuts M8-1.25 (Stand) ..................... 6
•
hex nut M8-1.25 (Quick release) .............. 1
•
hex nuts
3
⁄
8
-16 (Feet) ................................. 4
•
Flat Washers 10mm (Feet) ......................... 4
•
hex Wrench 6mm ....................................... 1
figure 4. Bandsaw, stand, motor, and
components
A
C
B
figure 5. table, miter gauge, and hardware
bags.
d
e
figure 6. Main fence components.
F
g
h
i
J
K
l
M
n
o
p
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.