Grizzly G0457 - Manual (Page 20)

-18-
g0457 14" industrial Bandsaw (Mfg. Since 5/11)
15. replace the blade, and for now, only put
enough tension on it to keep it on the
wheels.
16. re-install the table pin and table insert.
17. Fasten the rear rail to the back of the table
with the four M6-1 x 16 cap screws, as shown
in
figure 15.
figure 15. rear rail installed.
19. install the handle on the fence assembly
( figure 17), and tighten the hex nut against
the fence pivot block to secure the handle.
18. Attach the front rail to the front of the bandsaw
table with the two M6-1 x 20 hex bolts, 6mm
lock washers and flat washers, as shown in
figure 16.
figure 16. installed front rail.
figure 17. handle installed on fence assembly.
pivot Block
hex nut
20. place the 8mm flat washer on the locking
adjustment handle and slide it through the
hole in the fence.
21. thread the moving plate onto the end of the
locking adjustment handle threads.
22. Slide the resaw fence over the moving plate,
as shown in figure 18, so the moving plate
fits inside the channel of the resaw fence.
figure 18. Attaching resaw fence to standard
fence.
Moving
plate
locking
Adjustment
handle