Beginning assembly, Base/column – Grizzly G4008 User Manual

Page 10

Advertising
background image

-8-

G4008/G4009 Drill Press

Beginning Assembly

Most of the Drill Press has been pre-assembled
at the factory. The few remaining pieces should
go together quickly and easily. This manual is
written for both the G4008 and G4009. The only
difference between the two regarding assembly is
the length of the column.

CAUTION:

All die-cut metal parts have a sharp

edge (called “flashing”) on them after they are
formed. This is removed at the factory.
Sometimes though, a bit of flashing might escape
inspection. Please examine the edges of all die-
cut metal parts before handling them.

Tools Required:

Only a few common tools are

needed to assemble this machine. Specifically, a
14mm open end wrench, Phillips screwdriver and
3mm and 4mm Allen wrench.

SECTION 2: ASSEMBLY

Figure 3.

Base/Column

1.

Place the base on the floor (if G4009) or on a
suitable bench (if G4008). In either case, be
sure the surface is flat and stable.

2.

Place the column onto the base, line up the
four holes and secure with the four M10-1.5 x
40mm Hex Head Bolts and lock washers pro-
vided.

Figure 3.

Advertising