Grizzly G0529 - Manual (Page 14)

-12- g0529 oscillating Spindle & disc Sander
installing spindle mounting sander
to install the spindle onto the sander:
1. disconnect the machine from the power
supply.
2. Select the proper diameter of spindle
sleeve.
the Model g5029 comes with the following
four sizes of spindle sleeves:
• 1 ⁄
4
"
• 5 ⁄
8
"
• 1 1 ⁄
2
"
• 2"
3. Make sure the tapered end of the spindle
sleeve is clean before installing it into the
sander spindle.
4. use the supplied open end wrenches to
secure the spindle as shown in figure 6.
note—Do not over tighten the spindle sleeve,
it could make removal difficult.
figure 7. installing spindle.
figure 6. Cabinet hole location.
When the cabinet has been completed, it is time
to place the sander unit on top of the cabinet
stand.
to mount the sander to the top of the cabinet
stand:
1. With the help of an assistant, place the
sander on the cabinet stand.
the model g0529 weighs
166 lbs. personal injury
could occur if the
machine is moved with-
out additional assis-
tance. seek help when
moving or lifting the
machine.
2. align the holes on the rim of the cabinet
sides with the threaded holes in the rim of the
sander.
3. Secure the cabinet and the sander together
with the 5 ⁄
16
"-18 x 1 1 ⁄
4
" hex bolts, 5 ⁄
16
" lock
washers, and 5 ⁄
16
" flat washers combination
as shown in figure 5.