Grizzly G0529 - Manual (Page 32)

-30- g0529 oscillating Spindle & disc Sander
machine operation continued
Symptom possible Cause possible Solution
Machine slows
when
operating.
1. applying too much pressure to workpiece.
2. undersized circuit or using ext cord.
1. Sand with less pressure—let the movement of the
sleeve/disc do the work.
2. Make sure circuit wires are proper gauge & don’t use
ext cords!
Machine vibrates
excessively. 1. Stand not stable on floor.
2. incorrect motor mounting.
3. incorrect sanding sleeve tension.
4. Broken/defective sanding sleeve/disc.
1. Secure stand to floor, reposition to level surface, or
shim stand.
2. Check/adjust motor mounting.
3. Make sure tension lever is in tensioning position.
Follow sleeve tensioning instructions in this manual.
4. replace sanding sleeve/disc.
Workpiece frequent-
ly gets pulled out of
your hand. 1. not supporting the workpiece against the
stop.
2. Starting the workpiece on a leading corner.
1. use back stop to support workpiece.
2. Start workpiece on a trailing corner.