Grizzly G0529 - Manual (Page 22)

-20- g0529 oscillating Spindle & disc Sander
serious personal injury
could occur if you con-
nect your machine to the
power source during the
maintenance process.
do not connect the
machine to the power
source while performing
any maintenance on this
machine.
your safety is important! please follow the
warnings below during this entire section:
check for the following conditions before you
use the sander:
• loose table bolts.
• Worn or damaged sanding discs or
sleeves.
• Worn or damaged wires.
• any other condition that could hamper
the safe operation of this machine.
perform the following tasks at the scheduled
time intervals:
after each use
• Wipe off the sawdust build-up from
the table surface.
• turn off power switch and remove
the switch key.
• Check for spindle straightness.
Weekly
• Wipe a lubricant such as Slipit ® onto
the table.
• all the bearings are permanently
lubricated and require no further lubri-
cation
long-term storage
• Keep unpainted surfaces rust free
with products such as Boeshield ®
t-9.
schedule maintenance safety
section 7: maintenance