Control panel and knobs, Oven air vents – GE C2S980 User Manual

Page 37

Advertising
background image

37

ge.com

Upper Control Panel

Lock out the touch pads before cleaning.

See the Gas/Control Lockout information
in the Special features of your oven control
section in this manual.

Clean up splatters with a damp cloth.

You may also use a glass cleaner.

Remove heavier soil with warm soapy water.
Do not use abrasives of any kind.

Unlock the touch pads after cleaning.

See the Control Lockout information in the
Special features of your oven control section
in this manual.

Oven Air Vents

Never block the vents (air openings) of the
range. They provide the air inlet and outlet
that are necessary for the range to operate
properly with correct combustion.

Air openings are located at the rear of
the cooktop, at the top and bottom of the
oven door, and at the bottom of the range,
under the lower oven drawer.

Lower Control Panel and Knobs

It’s a good idea to wipe the control panel
after each use of the oven. Clean with
mild soap and water or vinegar and water,
rinse with clean water and polish dry with
a soft cloth.

Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven
cleaners on the control panel—they will
damage the finish. A 50/50 solution of
vinegar and hot water works well.

The control knobs may be removed for easier
cleaning.

Make sure the knobs are in the OFF positions
and pull them straight off the stems for
cleaning.

The knobs can be cleaned in a dishwasher
or they may also be washed with soap and
water. Make sure the insides of the knobs
are dry before replacing.

Replace the knobs in the OFF position
to ensure proper placement.

Metal parts can be cleaned with soap
and water. Do not use steel wool, abrasives,
ammonia, acids or commercial oven cleaners.
Dry with a soft cloth.

NOTE: The lower oven drawer control knob is
not interchangeable with the surface burner
knobs. Be sure to reinstall the lower oven
drawer knob to the original location. The lower
oven drawer knob may be identified by the
increasing numbers from “W

M

” to “450.”

Vent appearance and location vary.

Consumer

S

uppor

t

Installation

Instructions

Tr

oubleshooting

Tips

Operating

Instructions

Safety

Instructions

Surface burner knob

Advertising