GE JGRS06 User Manual
Page 27
Operating Instructions
Safety Instructions
Consumer Support
Tr
oubleshooting T
ips
27
Problem
Possible Causes
What To Do
Oven light does not work
Light bulb is loose or defective.
• Tighten or replace the bulb.
The pad operating the oven light
• Call for service.
is broken.
“Crackling” or
This is the sound of the
• This is normal.
“popping” sound
metal heating and cooling
during cooking.
“F—and a number or
You have a function error code.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
letter” flash in the display
one hour. Put the oven back into operation.
Function error code repeats.
• Disconnect all power to the oven for 5 minutes
and then reconnect power. If the function error
code continues repeating, call for service.
Display goes blank
A fuse in your home may be
• Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the
• See the Special features of your oven control section.
black-out mode.
Display flashes
Power failure.
• Reset the clock.
Unable to get the
Oven control pads were
• The BAKE and BROIL HI/LO pads must be touched at
display to show “SF”
not touched properly.
the same time and held for 2 seconds.
Power outage,
Power outage or surge.
• Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
“Burning” or “oily”
This is normal in a new oven
odor emitting from
and will disappear in time.
the vent
Strong odor
Improper air/gas ratio in oven.
• Adjust the oven burner air shutter.
Insulation around the inside
• This is normal in a new oven, and will disappear
of the oven.
in time.
Fan noise
A cooling fan may turn on
• This is normal. The fan will run until the function
and off automatically.
is over or the door is opened.
Burners have yellow or
Combustion quality of
• Use the illustrations below to determine if your
yellow-tipped flames
burner flames needs to be
burner flames are normal. If burner flames look
determined visually.
like A, call for service. Normal burner flames should
look like B or C, depending on the type of gas you
use. With LP gas, some yellow tipping on outer cones
is normal.
A–Yellow flames
B–Yellow tips
C–Soft blue flames
Call for service
on outer cones
Normal for natural
Normal for LP gas
gas
www.GEAppliances.com