Grizzly 12" Parallelogram Jointer G0609 - Manual (Page 20)

G0609 12" Parallelogram Jointer
-17-
Pedestal Switch
The pedestal switch is upside down for shipping
purposes.
Components and Hardware Needed: Qty
• Flat Washers 10mm (Pedestal) .................. 2
• Lock Washers 10mm (Pedestal) ................ 2
• Cap Screws M10-1.5 x 25 (Pedestal) ........ 2
• Pedestal Switch .......................................... 1
To set up the pedestal switch:
1. Remove the M10-1.5 x 25 cap screws and
flat washers shown in Figure 11.
2. Turn the pedestal upright and fasten it to
the jointer with the cap screws and washers
removed in
Step 1, as shown in Figure 12.
Figure 11. Location of pedestal mounting
hardware (one side shown).
Winding Cutterhead
Guard
Though the cutterhead guard is pre-installed, you
should check to make sure it works.
1. Pull the guard back and let it go. The guard
should spring back over the cutterhead.
— If the guard drags across the table, loosen
the set screws on the guard, raise it slight-
ly, then tighten the set screws.
— If the guard does not spring back over the
cutterhead, loosen the set screws on the
jointer shown in
Figure 10, hold the guard
over the cutterhead, and wind the shaft
collar clockwise. Tighten the set screws.
Check to see if the guard works and adjust
the collar as needed.
Figure 10. Loosening set screws.
Figure 12. Mounting pedestal in upright position.
Set
Screws
Shaft
Collar