Grizzly 12" Parallelogram Jointer G0609 - Manual (Page 43)

-40-
G0609 12" Parallelogram Jointer
������������
�������������
�������� � �
��
��
������������
Figure 53. Using feeler gauges to set outfeed
table height.
5. Place the straightedge on the outfeed table
so it hangs over the cutterhead, and lower
the outfeed table until the straightedge is
0.062" (
1 ⁄
16
") above the cutterhead body, as
determined by using the feeler gauges (see
Figure 53).
The infeed table on the Model G0609 has
positive stop bolts that, when properly set up,
allow the operator to quickly adjust the infeed
table between finish/final cuts and shaping/heavy
cuts.
We recommend setting the minimum depth of cut
to
1 ⁄
32
" and the maximum depth of cut to 1 ⁄
8
" for
most operations. DO NOT exceed 1 ⁄
8
" cut per
pass on this machine or kickback and serious
injury may occur!
Each positive stop bolt ( Figure 54) controls the
top or bottom range of the table movement. The
jam nuts lock the positive stop bolts in position so
they won't move during operation.
Setting Infeed Table
Figure 54. Positive stop bolts for infeed table.
Top Height Bottom
Height
6. Tighten the outfeed table lock located at the
front of the machine, and tighten the positive
stop bolts and jam nuts located at the back of
the machine (see
Figure 47).
7. Set the knife heights (Page 34) to the new
outfeed table height.
Jam Nut Jam Nut