Grizzly 12" Parallelogram Jointer G0609 - Manual (Page 33)

-30-
G0609 12" Parallelogram Jointer
Cleaning the Model G0609 is relatively easy.
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. If any
resin has built up, use a resin dissolving cleaner
to remove it. Treat all unpainted cast iron and
steel with a non-staining lubricant after cleaning.
Cleaning
SECTION 6: MAINTENANCE
Protect the unpainted cast iron surfaces on the
table by wiping the table clean after every use—
this ensures moisture from wood dust does not
remain on bare metal surfaces.
Keep tables rust-free with regular applications of
products like G96
® Gun Treatment, SLIPIT ® , or
Boeshield ® T-9 (see SECTION 5: ACCESSORIES
on Page 27 for more details).
Unpainted Cast Iron
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Maintenance
• Vacuum all dust on and around the
machine.
• Wipe down tables and all other unpainted
cast iron with a metal protectant.
Monthly Maintenance
• Inspect V-belts for tension, damage, or
wear.
• Clean/vacuum dust buildup from inside cabi-
net and off of motor.
Schedule
Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
Lubrication
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.