GE TAD-732 - Manual (Page 24)

24
• If the TAD’s memory is full ( FL flash-
es) you must delete some messag-
es before you can record a new
outgoing message.
Using the Handset
1. Press REMOTE . The REMOTE indi-
cator lights and –– appears on the
base.
2. Press CHANGE ( ) then ANNC (0) .
The handset beeps once.
3. Speak your message in a normal
voice, as though you were talking to
someone on the phone.
4. Press STOP (5) when you finish the
message. The TAD plays back the
outgoing message, then beeps
twice.
5. Press REMOTE . The REMOTE indi-
cator turns off.
To play the outgoing message at any
time, press
REMOTE then ANNC (0) on
the handset, or press ANNC on the
base.
Note: You can only use the handset to
record the outgoing messages and
memos. But you can play messages by
using the base or handset.
Deleting an Outgoing Message
To delete your outgoing message and
use the prerecorded message, press
DELETE then ANNC on the base, or RE-
MOTE , DELETE (9) , then ANNC (0) on the
handset.
43-732.fm Page 24 Friday, August 13, 1999 1:42 PM