GE TAD-732 - Manual (Page 9)

9
7. Plug the adapter into a standard AC
outlet. The TAD-732 beeps and 00
appears.
8. Raise the base’s antenna to a verti-
cal position.
Mounting the Base on a Wall
Plate
1. Remove the mounting bracket by
holding in both tabs and gently pull-
ing out the wide end of the bracket.
2. Plug one end of the supplied short
modular cord into the telephone jack
on the back of the base.
3. Insert the supplied AC adapter’s
barrel plug into the DC 9V jack on
the back of the base.
4. Route the modular cord through the
left groove on the bottom of the
base and the adapter cord through
the groove below the strain relief
slot.
Strain
Relief
Slot
43-732.fm Page 9 Friday, August 13, 1999 1:42 PM