Grizzly 10" x 22" Benchtop Lathe G0602 - Manual (Page 19)

Model G0602/G0752 (Mfg. Since 11/12)
-17-
inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
installed components (figure 10) Qty.
a. 5" three-Jaw Chuck ................................... 1
b. steady rest ................................................ 1
c. Follow rest ................................................. 1
d. 4-Way tool post ......................................... 1
e. Compound rest ......................................... 1
f. tailstock ...................................................... 1
figure 11. packaged components.
i
J
K
l
M n
o
p
Q
r
s
u V
W
h
t
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
figure 10. installed components.
d e A B C F
packaged components (figure 11) Qty.
g. Chip pan (not shown) ................................ 1
h. hex Wrench set (2.5, 3, 4, 5, 6 mm) .....1 ea
i. tool Box...................................................... 1
J. 8" Faceplate ............................................... 1
K. 6 1 ⁄
2
" 4-Jaw universal Chuck ....................... 1
l. low range Belt 27 1 ⁄
2
" (g0602) .................. 1
high range Belt 33" (installed, g0602) ..... 1
V-Belt 33" (installed, g0752) ...................... 1
m. #2 phillips and standard screwdriver ...1 ea
n. Wrench set (8/10, 12/14, 19/17mm) .......1 ea
o. 3-Jaw Chuck internal Jaw set .................... 1
p. 3-Jaw Chuck Key ....................................... 1
Q 4-Jaw Chuck Key ....................................... 1
r. oil Bottle for oil .......................................... 1
s. Cross slide handwheel handle ................. 1
t. Carriage handwheel handle ...................... 1
u. dead Centers Mt#3 .................................. 2
v. dead Center Mt#4 ..................................... 1
W. Change gear set ....................................... 1
— Change gear (27-tooth, installed) ......... 1
— Change gear (36-tooth) ......................... 1
— Change gear (40-tooth) ......................... 1
— Change gear (44-tooth) ......................... 1
— Change gear (45-tooth) ......................... 1
— Change gear (46-tooth) ......................... 1
— Change gear (48-tooth) ......................... 1
— Change gear (52-tooth) ......................... 1
— Change gear (56-tooth, installed) ......... 1
— Change gear (60-tooth) ......................... 1
— plastic drive gear (60-tooth, installed) .. 1
— Change gear (104-tooth, installed) ....... 1
— Change gear (120-tooth) ....................... 1
— Change gear (127-tooth, installed) ........ 1
X. Frequency drive Manual VFd-e (g0752, not
shown) ....................................................... 1