Grizzly G0513X2 - Manual (Page 22)

-20-
G0513 Series Bandsaws
We recommend mounting your new machine to
the floor. Because floor materials may vary, floor
mounting hardware is not included. you may also
mount your machine to a mobile base that has
wheel locking or wheel retracting capabilities that
keeps the mobile base from rolling when not in
use.
Bolting to concrete Floors
lag shield anchors with lag bolts (see Figure 14)
and anchor studs (see Figure 15) are two popular
methods for anchoring an object to a concrete
floor. We suggest you research the many options
and methods for mounting your machine and
choose the best that fits your specific application.
Mounting
Figure 14. typical lag shield anchor and bolt.
Figure 15. typical anchor stud.
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
which may cause a tripping hazard if you
decide to move your machine.
Assembly
Installing Guide Post Handwheel,
Positive Stop Bolt, & Table
1. secure the guide post handwheel onto the
handwheel shaft flat with the included set
screw (see
Figure 16).
Figure 16. guide post handwheel installed.
guide post
handwheel
2. thread the M8-1.25 hex nut halfway onto the
M8-1.25 x 90 hex bolt (this is the positive stop
bolt).
3. thread the positive stop bolt into the thread-
ed hole on bandsaw body (see Figure 17).
Figure 17. positive stop bolt installed.
positive stop