Grizzly G0513X2 - Manual (Page 60)

-58-
G0513 Series Bandsaws
symptom possible Cause possible solution
Machine stalls
or slows when
operating. 1. too much pressure against workpiece.
2. Workpiece too moist or unsuitable.
3. Workpiece is warped.
4. Fence incorrectly adjusted.
5. V-belt slipping.
6. run capacitor at fault.
7. Motor connection wired incorrectly.
8. Motor overheated.
9. Contactor has poor contacts or is at fault.
10. Centrifugal switch at fault.
11. Motor at fault.
1. decrease the feed rate or workpiece pressure.
2. only cut wood and ensure moisture is below 20%.
3. straighten workpiece or use a different one.
4. adjust/calibrate fence (
Page 37).
5. tension/replace V-belt ( Page 60); ensure pulleys
are aligned.
6. test/repair/replace.
7. Wire motor correctly. refer to diagram inside junction
box or the wiring diagrams beginning on Page 69.
8. let cool, clean motor, and reduce workload.
9. test all legs for power, test field coil, and fix contacts
or replace if at fault.
10. adjust/replace centrifugal switch if available.
11. test for shorted windings, bad bearings and repair
or replace.
Miter bar binds in
miter slot. 1. Miter slot dirty or gummed up. 1. Carefully clean miter slot.
table does not tilt
to 0 degrees. 1. pointer or scale calibrated incorrectly.
2. positive stop bolt not set correctly. 1. Calibrate pointer/scale at true 0 degrees.
2. adjust positive stop bolt (
Page 26).
table does not tilt
to 45 degrees. 1. pointer or scale calibrated incorrectly.
2. Machine component blocking path. 1. Calibrate pointer/scale at true 45 degrees.
2. remove component blocking table.
table hard to tilt. 1. sawdust or pitch trapped between trunnion
and base.
2. Metal burrs on trunnion.
1. Clean/lubricate sliding surfaces of trunnions
( Page 56).
2. remove burrs.
Cuts are rough or
show scoring. 1. Blade is overloaded and twists.
2. Blade tpi is too coarse or speed incorrect.
3. Blade is loose and slipping on wheels.
4. Blade tracking is incorrect.
5. Blade has missing or bent teeth.
6. Blade has a faulty weld.
1. decrease the feed rate or workpiece pressure.
2. use correct blade for application (
Page 44).
3. re-tension blade ( Page 30).
4. adjust blade tracking ( Page 25) or adjust wheels
coplaner ( Page 65).
5. replace the blade ( Page 48).
6. replace the blade ( Page 48).
Blade or teeth
break. 1. Blade tension too high.
2. incorrect blade for application.
3. Feed rate or blade speed is too fast.
4. operator is cutting corners too sharply.
5. Blade is dull.
6. Blade tracking is wrong.
7. Blade guides adjusted incorrectly.
8. inadequate blade support near cutting
area.
9. Blade weld at fault.
10. Wheel tires worn or damaged.
11. Fence or miter slot not aligned with blade.
1. decrease blade tension ( Page 30).
2. use correct blade for application ( Page 44).
3. reduce feed rate or increase blade speed.
4. use a wider arc on outside cuts, or use relief cuts to
make tight inside cuts.
5. replace blade ( Page 48).
6. adjust blade tracking ( Page 43).
7. re-adjust blade guides ( Page 33).
8. adjust upper blade guide closer to workpiece
( Page 33).
9. replace blade ( Page 48).
10. replace tires.
11. align miter slot and fence with blade (
Page 36).