Grizzly G0513X2 - Manual (Page 29)

G0513 Series Bandsaws
-27-
Figure 34. dust hose attached to bottom dust
port.
Dust collection
To connect a dust collection hose:
1. Fit a 4" dust hose over each dust port and
secure them in place with a hose clamp (see
Figure 34).
2. tug the hoses to make sure they do not
come off.
Note: A tight fit is necessary for proper per-
formance.
Recommended cFM at Dust Port: 400 cFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
DO NOT operate this bandsaw without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust col-
lection system can result in short and long-
term respiratory illness.
Power cord
connection
(G0513X2BF &
G0513X2F)
the power cord connection Must be performed
by an electrician or qualified service personnel.
Items Needed Qty
Cord “s”-type, 3-Wire, 14 aWg, 300 VaC,
at least 6 ft. long ......................................... 1
phillips screwdriver #2 ...................................... 1
Wire Nuts for (2) 14 aWg Wires ........................ 3
Electrical tape ................................... as Needed
To connect the power cord to the machine:
1. attach the required plug to the cord per
the plug manufacturer's instructions (refer
to
Power Supply beginning on Page 11 for
specifications and the NEMa plug wiring on
Pages 71– 72).
2. remove the power supply junction box cover
from the right rear of the bandsaw (see
Figure 35). it is secured by two screws.
Serious injury could occur if you connect
the machine to power before completing the
setup process. DO NOT connect to power
until instructed later in this manual.
Figure 35. power supply junction box on rear of
bandsaw.
power supply
Junction Box
strain
relief