Grizzly Hanging 3 Speed Air Filter G0738 - Manual (Page 13)

model g0738 (mfg. since 1/12)
-11-
Power connection
to avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
connecting Power
insert the power cord plug into a matching power
supply receptacle. the machine is now connected
to the power source.
Figure 3. Connecting power.
Figure 4. Disconnecting power.
Disconnecting Power
grasp the molded plug and pull it completely out
of the receptacle. do not pull by the cord as this
may damage the wires inside.
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 19.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. make sure you have read the safety instruc-
tions at the beginning of the manual.
2. place the air filter on a workbench or similar
stable surface that can support the load.
3. Connect the air filter to power.
4. press the on spEEd button on the control
panel of the air filter (see Figure 5) to turn the
unit ON. the machine should run smoothly
with little or no vibration.
Figure 5. Air filter control panel.
— strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.