Grizzly Hanging 3 Speed Air Filter G0738 - Manual (Page 17)

model g0738 (mfg. since 1/12)
-15-
Note: Some positions for the ceiling hooks
may be slightly uneven from each another.
To make up for this, minor adjustments can
be made to the length of the hanging assem-
bly by adjusting the amount that the machine
hook is threaded into the air filter housing
(see
Figure 10). If you do this, tighten the
hex nut to secure the hook.
Figure 10. machine hook partially threaded to
adjust the hanging length.
hex nut
2. drill a 3 ⁄
32
" pilot hole into the center of the
joists at the mounting locations, then fully
thread the ceiling hooks into the joists (see
Figure 11).
Important: If the joists are covered with sheet
rock or paneling, use a stud finder or other
device to locate the center of the joists.
Joist
Ceiling
Hook
Machine
Hook
Figure 11. Air filter mounted to the joists.
3. Attach the provided chains to the ceiling
hooks.
4. With the help of another person to hold the air
filter up, attach the other end of the chains to
the machine hooks.
THIS AIR FILTER IS TO BE USED FOR
WOOD DUST ONLY. Do not use it to filter
toxic fumes, paint spray, or dissipate smoke
or fumes, which could damage the filters.