Grizzly G0477 - Manual (Page 17)

Model G0477 15" Planer/Moulder
-15-
Test Run
Once the assembly is complete, test run your
machine to make sure it runs properly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 25.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the machine:
1. Connect the machine to the power source.
2. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
3. Make sure all tools and objects used during
set up are cleared away from the machine.
4. Turn the machine ON.
5. Listen to and watch for abnormal noises or
actions. The machine should run smoothly
with little or no vibration or rubbing noises.
— Strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
Crank Handle
Components and Hardware Needed Qty
Cap Screw M5-.8 x 25 ....................................... 1
To install the crank handle (Figure 9):
1. Slide the handle onto the handle shaft locat-
ed at the front of the right housing cap.
2. Fasten with the cap screw.
Figure 9. Crank handle installed.