Grizzly G0477 - Manual (Page 18)

-16-
Model G0477 15" Planer/Moulder
Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving
machinery.
Operation Safety
SECTION 4: OPERATIONS
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
Safety Switch Key
To prevent the machine from starting, remove the
lockout key (
Figure 10) from the paddle switch.
Figure 10. Removing key to disable switch.
Basic Operation
The basic steps of operating the planer/
moulder are as follows:
1. Put on safety glasses, ear protection and a
respirator.
2. Unless your workpiece starts very flat, sur-
face plane the workpiece on a jointer until it
is flat.
3. Adjust the headstock height (see Page 18)
so that the planing knives are slightly lower
than your workpiece height to ensure the first
cut is as light as possible.
4. Start the planer/moulder.
5. Place the flat side of the board down on the
table, and feed the workpiece through the
planer/moulder, making sure not to stand
directly in front or behind the workpiece.