Grizzly G0528 - Manual (Page 16)

-14-
model g0528 (mfg. 5/04+)
Assembly
To assemble the machine:
1. Secure the rubber feet to the stand legs with
the four 1 ⁄
4
"-20 x 1" phillips screws, 1 ⁄
4
"-20 hex
nuts, and 1 ⁄
4
" flat washers ( figure 6).
4. using two 5 ⁄
16
"-18 x 1 1 ⁄
2
" cap screws, 5 ⁄
16
" flat
washers, and 5 ⁄
16
"-18 hex nuts, install the rub-
ber stops at the end of the flange brackets
(
figure 8).
figure 8. table support assembly.
Side Support
Flange bracket
5. at the pivot bolt locations (figure 7), attach
the flange bracket to the table with two 5 ⁄
16
"-18
x 1" hex bolts, six 5 ⁄
16
" flat washers, and two
5 ⁄
16
"-18 lock nuts.
marked " L" marked " R"
Front Support
figure 6. rubber feet installation.
Flange bracket
Front Support
Side Support
pivot hole
figure 7. table support and bracket order.
2. arrange the front support, side supports, and
the " L" and "R" flange brackets in the order
shown in figures 7–8. be sure that the pivot
holes in the flange brackets are located at the
orientation shown in
figure 7.
3. Fasten the brackets together at both ends of
the front support ( figure 8) with one 5 ⁄
16
"-18
x 1" hex bolt, two 5 ⁄
16
" flat washers, and one
5 ⁄
16
"-18 hex nut.
figure 9. table pivot installation.
pivot bolt
table
rubber Stop