Grizzly G0641 - Manual (Page 12)

-10-
G0641 Double Miter Saw
Inventory
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
Note: If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully. Occasionally
we pre-install certain components for shipping
purposes.
Inventory: (Figures 3) Qty
A. Double Miter Saw (not shown) ................... 1
B. Left Extension Wing w/Scale ...................... 1
C. Right Extension Wing ................................. 1
D. Support Legs w/Adjustable Floor Mounts .. 2
E. Hex Wrench Set 1.5–10mm ....................... 1
F. Combo Wrenches:
— 11/13mm ................................................. 1
— 12/14mm ................................................. 1
— 17/19mm ................................................. 1
— 22/24mm ................................................. 1
— 23/26mm ................................................. 1
G. Hardware Bag (not shown):
— Special Hex Bolts 5/8-11 x 2 3 ⁄
8
"
(lifting) ..................................................... 4
— Hex Nuts
5 ⁄
8
"-11 (lifting) ........................... 4
—Hex Bolts M8-1.25 x 25 (ext. wings) ...... 8
— Flat Washers 8mm (ext. wings) .............. 8
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
SUFFOCATION HAZARD!
Immediately discard all plas-
tic bags and packing materi-
als to eliminate choking/suf-
focation hazards for children
and animals.
B
C
D
E
F
Figure 3. Extension wings and tools.