Grizzly G0641 - Manual (Page 16)

-14-
G0641 Double Miter Saw
Assembly
Once you have secured the machine in its pre-
pared location, install the extension wings.
To assemble the double miter saw:
1. Turn the extension wings upside down on a
protected surface (see Figure 9).
2. Use a 13mm wrench to secure the support
legs to the extension wings with the M8-1.25
x 20 hex bolts and flat washers, as shown in
Figure 9.
3. Turn the support leg and extension wing
assemblies right side up and mount them to
the flanges on both sides of the saw table
(see
Figure 10) with the M8-1.25 x 20 hex
bolts and flat washers.
Note: The extension wing with the scale is
mounted on the left side of the machine.
4. Lay a long straightedge across the extension
wings and the saw table.
5. Adjust the supporting leg floor mounts so that
the extension wings are level with the table,
then tighten the jam nuts on the floor mounts
to secure the settings.
Figure 9. Extension wing with support leg
installed.
Support
Leg
Adjustable
Floor
Mounts
Hex Bolts &
Flat Washers
Extension
Wing
Figure 10. Extension wing mounted onto the
saw table.
Hex Bolts
& Flat Washers