Grizzly G0641 - Manual (Page 17)

G0641 Double Miter Saw
-15-
Required Air PSI ....................................... 70 PSI
Air Consumption ....................................... 4 CFM
Maximum Air PSI ...................................... 90 PSI
To connect the saw to compressed air:
1. Connect a source of compressed air to the
air regulator-lubricator inlet valve on the back
(see
Figure 11).
Figure 11. Air regulator-lubricator.
Air
Pressure
Knob
Air
Pressure
Dial
Air Inlet Valve
2. Lift up on the air pressure knob (see Figure
11), and turn it to adjust the air pressure dial
to 70 PSI, then push the knob down to lock
the setting.
3. Open the pneumatic access door on the right
side of the machine and set the air pressure
knob in a similar manner so that the air pres-
sure dial reads 70 PSI (see
Figure 12).
Figure 12. Internal air regulator.
Air Pressure
Dial
Air Pressure Knob
Air Supply
NOTICE
Exceeding 90 PSI may result in unpredict-
able operation of the saw and damage to
the pneumatic system.