Gefen GTV-HT-AUDPROC - Manual (Page 20)

16
SPEAKER SIZE
This menu option will allow the user to select the speaker size to either SMALL
or LARGE. When a speaker size is set to SMALL, all frequencies below 80Hz
are automatically routed to the subwoofer channel. When a speaker size is set to
LARGE, all frequencies will be routed to the speaker.
All speakers except the front left and right channels have an option to disable the
use of that channel. If the center, rear surround, or subwoofer channels are not
going to be used these speakers should be set to the OFF setting. Source audio
that uses these channels will be properly mixed to the other available speakers.
Use the ▼ and ▲ buttons on the front panel to select the desired speaker output.
The following selections are available:
• Front L/R - These settings will affect the front left and right channel outputs
(default is SMALL).
• Center - These settings will affect the center channel outputs (default is
SMALL).
• Surr L/R - These settings will affect the surround left and right channel
outputs (default is SMALL).
• SUB - This should be set according to the use of a subwoofer (default is
ONSUB).
Use the ◄ and ► buttons on the front panel to change options for the selected
speaker.
When fi nished, press the ▼ or ▲ to move to another selection. Alternatively, the
user can press the OK button to immediately cycle to the next option.
To return to the previous menu, press the EXIT button. To exit the entire Menu
System, press the MENU button.
SPEAKER LEVEL
This menu option will allow the user to increase or decrease the volume of a
particular speaker. This feature is useful for equalizing the sound at the listening
position. By default, each speaker’s output is set at 00dB. The output can be
adjusted in 1dB increments between -10dB and +10dB.
Once a speaker is selected for adjustment, the INFO/TEST TONE button on the
IR remote control can be used to activate a test tone which will be heard through
the selected speaker output.
Use the ▼ and ▲ buttons on the front panel to select the desired speaker output.
The following selections are available:
• Front L - These settings will affect the front left channel output (default is
+00dB).
• Center - These settings will affect the center channel output (default is
+00dB).
OPERATING THE HOME THEATER AUDIO PROCESSOR