Grizzly G0492 - Manual (Page 15)

G0492 12" X 36" Combo Lathe/Mill
-13-
After all the parts have been removed from the two
boxes, you should have the following items:
Installed Accessories (Figure 3) .................... Qty.
A. 6" Three-Jaw Chuck ..................................... 1
B. 4-Way Tool Post and Compound Rest ........ 1
C. Follow Rest ................................................... 1
D. Steady Rest .................................................. 1
Packaged Accessories (Figure 4)
E. 8" Four-Jaw Universal Chuck ....................... 1
F. 8" Faceplate ................................................. 1
G. Four-Jaw Chuck Key .................................... 1
H. Drill Chuck (1-13mm, JT-33) ........................ 1
I. Wrench Set (8/10, 10/12, 14/17, and
17/19 mm) .............................................. 1 EA
J. Hex Wrench Set (4, 5, 6, 8 mm) ............ 1 EA
K. Three-Jaw Chuck Key .................................. 1
L. Oil Can ......................................................... 1
M. Dead Center MT#5 ....................................... 1
N. #2 Standard Screwdriver .............................. 1
O. Wedge .......................................................... 1
P. Tool Post T-Handle Wrench ......................... 1
Q. Dead Center MT#3 w/Arbor ......................... 1
R. Three-Jaw Chuck Internal Jaws ................... 3
S. Arbor JT-33 to MT#3 .................................... 1
T. Spot Paint ..................................................... 1
U. Drill Chuck Key ............................................. 1
V. Change Gear Set ......................................... 1
— Gear (24-fine Tooth), (Installed) .............. 1
— Gear Set (28 & 35-Coarse Tooth) ........... 1
— Change Gear (24-tooth, 1 Installed) ........ 2
— Change Gear (25-tooth, 1 Installed) ........ 2
— Change Gear (27-tooth) .......................... 1
— Change Gear (28-tooth) .......................... 1
— Change Gear (30-tooth) .......................... 1
— Change Gear (32-tooth) .......................... 2
— Change Gear (34-tooth) .......................... 1
— Change Gear (35-tooth) .......................... 1
— Change Gear (36-tooth) .......................... 1
— Change Gear (40-tooth) .......................... 1
— Change Gear (42-tooth) .......................... 1
— Change Gear (44-tooth) .......................... 1
— Change Gear (46-tooth) .......................... 1
— Change Gear (48-tooth, Installed) ........... 1
— Change Gear (50-tooth, Installed) ........... 1
— Change Gear (52-tooth) .......................... 1
— Change Gear (60-tooth, Installed) ........... 1
Figure 3. Installed accessories.
Figure 4. Packaged accessories.
G
E
H
F
D
A
K
J
U
V
S
T
R
Q
P
O
N
M
L
I
B
C
Inventory
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss-
ing.