Grizzly G0492 - Manual (Page 28)

-26-
G0492 12" X 36" Combo Lathe/Mill
The compound rest is used to cut tapers on parts
or to set the proper infeed angle when threading.
It may also be used to cut specific lengths longitu-
dinally, when set parallel to the spindle axis.
To set the angular position:
1. Loosen the hex nuts, one on each side of the
compound rest (see Figure 28).
2. Rotate the compound rest to the desired
angular position using the scale.
3. Tighten the two hex nuts. Be sure to not over-
tighten, as you may strip threads or crack or
distort the base casting.
The four-way tool post ( Figure 29) is mounted on
top of the compound rest, and allows a maximum
of four tools to be loaded simultaneously.
The four-way tool post allows for quick indexing
to new tools. This is accomplished by rotating the
top handle counterclockwise and then rotating the
tool post to the desired position. Rotate the top
handle clockwise to lock the tool into position.
Figure 29. Four-way tool post.
Figure 28. Compound rest, scale, and
handwheel.
Scale Hex Nut
Using the
Compound Rest
Using the Tool Post