This module has several user-accessible features, Four leds are located at the top of the board – GE GFK-1541B User Manual
Page 15
2-2
TCP/IP Ethernet Communications for the Series 90™ PLC User's Manual
–
May 2002
GFK-1541B
2
Installing an IC693CMM321 Ethernet Interface Module
The IC693CMM321Ethernet Interface mounts in a Series 90-30 PLC baseplate. It connects to an
Ethernet network either directly through its 10Base-T port (10Base-T Type only), or through its
AAUI port, which requires a user-provided transceiver and cable. If using the AAUI port, you
may order a transceiver from GE Fanuc (see Appendix B for information) or supply your own
equivalent transceiver. .
IC693CMM321 Series 90-30 TCP/IP Ethernet Interface (10Base-T Type)
CMM321 versions EF or earlier do not have a 10Base T port.
OK
LAN
FDX
STAT
FDX
OK
LAN
RESTART
PUSHBUTTON
STAT
RS-232 STATION
MANAGER
PORT (RJ-11)
10BASE-T
PORT (RJ-45)
CMM321
ETHERNET
INTERFACE
AAUI PORT
10BASE-T
STATION
MGR
RS-232
ETHERNET
RESTART
Default Station
Address Label
(Internal)
Serial Number
Label (Internal)
This module has several user-accessible features:
Four LEDs are located at the top of the board.
The Restart pushbutton is located immediately below the LEDs.
The Station Manager port (RS-232 serial port with an RJ-11 connector) is located on the front
of the module.
The 10Base-T Ethernet port (RJ-45 connector) is located on the front of the module. It does
not require an external transceiver.
The AAUI port (14-pin AAUI connector) is accessible through an opening in the bottom of
the module. It requires an external transceiver.
The Default Station Address label lists the MAC address to be used by this Interface. It is
located by removing the module’s front cover and looking on the circuit board.
The module’s serial number is on the silver label on the left side of the module.