GE GFK-1541B - Manual (Page 212)

GFK-1541B Appendix B Communications Port Characteristics B-11
B
10Base2 Port
The IC697CMM742 Series 90-70 Ethernet Interface (Type 2) is equipped with a 10Base2 port for
direct connection to a 10Base2 (thin wire) coaxial cable network, without addition of an external
transceiver. The 10Base2 port on the Ethernet Interface is connected to the 10Base2 network
cables by a BNC Adapter (female, male, female, in either “T” or “F”configurations).
Your 10Base2 network cables and connectors must meet the applicable IEEE 802 standards.
Information in this section includes 10Base2 port pinouts and cable diagrams.
10Base2 Port Pinouts
The 10Base2 port is located on the front of the Series 90-70 Ethernet Interface. This port is a
female BNC coaxial connector. It is used to connect the Ethernet Interface to the 10Base2
network.
Pin Number Signal Description
S TD/RD Transmit and Receive Data
G GND Shield Ground
Note
Pinouts are provided for troubleshooting purposes only. 10Base2 cables are
readily available from commercial distributors. GE Fanuc recommends
purchasing rather than making 10Base2 cables.