Gefen EXT-DVIRS232-1FO - Manual (Page 10)

7
RECEIVER UNIT DESCRIPTIONS
1 RS-232
Connect an RS-232 cable from this port to the RS-232 device.
2 DVI Out
Connect a DVI display to this DVI port.
Calibration Indicator
This LED will alternate from red to green during the calibration procedure. The
LED will turn solid green once the calibration procedure has been completed.
See page 12 for more information on the calibration procedure.
3 Power Indicator
This two-color LED will turn bright red once the included 5V DC locking power
supply has been properly connected to the unit and the locking power supply
has been connected to an available wall outlet. This LED will turn bright green
once the Sender unit and Receiver unit are communicating correctly.
4 5V DC Locking Power Connector
Connect the included 5V DC Locking Power Supply to this receptacle.
5 Fiber Optic Connector (SC-Type)
This connector accepts a single strand of SC-terminated fi ber optic cable that
will link the Sender unit and Receiver unit together. The Gefen Extender for DVI
and RS232 Over One Fiber Optic Cable will only accept multi-mode fi ber optic
cabling.