Gefen EXT-DVIRS232-1FO - Manual (Page 13)

10
DIP SWITCH CONFIGURATION
DIP 2 - Deep Color
• OFF - Enables Deep Color support (12-bit color)
Enables Deep Color support. In Pass-through EDID Mode, setting DIP 2 to
the OFF position has no effect since all EDID information is passed through.
• ON - Forces 8-bit Color
Disables Deep Color in the EDID. Deep Color management is only available
when Local EDID is being used.
DIP 3 - Calibration Mode
• OFF - Enables Calibration Mode
Enables Calibration Mode. Make sure to set DIP switch 3 on both the
Sender unit and Receiver unit when calibrating the Extenders. See page 12
for details.
• ON - Calibration Mode Lock
Locks the calibration settings. Set DIP switch 3 on both the Sender unit and
Receiver unit to the ON position after the calibration process has completed.
See page 12 for details on the calibration process.
NOTE: DIP switch 2 is only functional when DIP switch 1 is set to the
OFF position.