Grizzly H7583 - Manual (Page 10)

-8-
H7583 Tenoning Jig
The unpainted surfaces are coated with a waxy
oil to protect them from corrosion during ship-
ment. Remove this protective coating with a sol-
vent cleaner or citrus-based degreaser such as
Grizzly’s G7895 Degreaser. To clean thoroughly,
some parts may need to be removed.
For opti-
mum performance from your machine, make
sure you clean all moving parts or sliding
contact surfaces that are coated. Avoid chlo-
rine-based solvents, such as acetone or brake
parts cleaner, as they may damage painted sur-
faces should they come in contact. Always follow
the manufacturer’s instructions when using any
type of cleaning product.
Clean Up
Gasoline and petroleum
products have low flash
points and could cause
an explosion or fire if
used to clean machinery.
DO NOT use gasoline or
petroleum products to
clean the machinery.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest-
ed. Lack of ventilation
while using these sol-
vents could cause seri-
ous personal health risks
or fire. Take precautions
from this hazard by only
using cleaning solvents
in a well ventilated area.
Always disconnect power
to the machine before
performing adjustments
or maintenance. Failure
to do this may result in
serious personal injury.
The Model H7583 Tenoning Jig is made to oper-
ate in a
3 ⁄
8
" x 3 ⁄
4
" miter T-slot. If the tenoning jig
operates on a worn or mis-adjusted saw, tenon-
ing results will be poor. Review the following list to
make sure you prepare your saw correctly.
• Table Saw Operation: Make sure that you
read and understand your table saw instruc-
tion manual, and take all safety precautions.
• Saw Blades: Make sure that your saw
blades have no runout and that the teeth are
sharp.
• Saw Adjustments: Make sure that your
table saw blade is perpendicular to the table
and parallel with the miter slots.
• Miter Slot and Table: Make sure the table-
saw miter slots are
3 ⁄
8
" x 3 ⁄
4
", and the table is
free of burrs and interferences that may bind
the tenoning jig.
• Lighting: Make sure the top of your table
saw has adequate lighting, so the tenoning
jig and workpiece is illuminated without shad-
ows.
Table Saw
Preparation
DO NOT remove the washer from the miter
bar of the tenoning jig. Removal of the
washer will allow the tenoning jig to come
loose during a kickback, possibly causing a
serious personal injury.