Grizzly Heavy Duty Mill/ G1006 - Manual (Page 24)

"''"
BdYZa<&%%+$<&%%, B[\#H^cXZ.$%.
Handwheels
There are three handwheels provided with the
machine that control table movement. The Model
G1007 only uses two of the handwheels.
To mount the handwheels to the machine:
1. Turn the lock nut on the handwheel handles
until it is almost against the plastic handle.
2. Screw the handle into the handwheel and
tighten the lock nut against the wheel. This
nut acts as a locknut and a spacer (Figure
18).
Head Crank
The head crank secures to the left side of the
machine and is used to adjust the height of the
headstock.
To mount the head crank to the machine:
1. Assemble the head crank by attaching the
handle in the same method used for the
handwheels. Thread the handle into the
crank body, then tighten the lock nut.
2. Slide the head crank onto the shaft, then
tighten the set screw to secure it in place
(Figure 20).
Figure 20. Head crank.
Figure 18. Handwheel assembly.
3. Secure one handwheel in each of the loca-
tions shown by sliding the handwheel onto
the leadscrew and tightening the set screw
(Figure 19).
Figure 19. Handwheel installation.
Handwheel Lock Nut
G1006 Only
Set Screw
Head Crank