Grizzly Heavy Duty Mill/ G1006 - Manual (Page 30)

"'-"
BdYZa<&%%+$<&%%, B[\#H^cXZ.$%.
Spindle Height Note: Locking out the levered downfeed
will transfer control to the handwheel. The
handwheel will not function if the locking knob
is loose.
2. Loosen the setscrew on the rim surface of
the handwheel dial. Turn the dial until the "0"
lines up with the index line. Tighten the set-
screw.
3 Turn the handwheel according to the distance
you want to move downward. Each complete
revolution equals 0.100".
To lock the spindle:
1. Tighten the spindle locking lever to lock the
spindle for milling operations.
You have two options for spindle height adjust-
ment—a drill press style, levered downfeed and
a micro adjustment handwheel. To operate the
downfeed lever, simply pull forward and down on
the lever nearest you. The spindle will go down
until you stop pulling or until it hits the depth
stop.
To operate the micro-adjustment handwheel:
1. Tighten the locking knob located on the
center of the hub for the down-feed levers
(Figure 29).
Figure 29. Micro-adjustment handwheel.
Locking Knob
Micro-Adjustment
Handwheel